Closed Willemthefirst closed 2 years ago
Cura 4.x or Cura 5.0 ?
Cura 5.0, sorry I vergot that to mentioned
Kurt Hennig
5axes @.***> schrieb am Mi., 1. Juni 2022, 08:29:
Cura 4.x or Cura 5.0 ?
— Reply to this email directly, view it on GitHub https://github.com/5axes/Calibration-Shapes/issues/99#issuecomment-1143170226, or unsubscribe https://github.com/notifications/unsubscribe-auth/ANVMUV36PUR3EGWWK52OCRLVM37OBANCNFSM5XOQ4MQA . You are receiving this because you authored the thread.Message ID: @.***>
Could be an issue in this case with the parameter : "Wall Ordering" the default value brings a lot of problem. Try to set this value to "Inside To Outside".
Thanks, I'll check it out.
5axes @.***> schrieb am Mi., 1. Juni 2022, 09:38:
Could be an issue in this case with the parameter : "Wall Ordering" the default value brings a lot of problem. Try to set this value to "Inside To Outside".
— Reply to this email directly, view it on GitHub https://github.com/5axes/Calibration-Shapes/issues/99#issuecomment-1143225067, or unsubscribe https://github.com/notifications/unsubscribe-auth/ANVMUV4FX3YMBFHEKJQI7JDVM4HPRANCNFSM5XOQ4MQA . You are receiving this because you authored the thread.Message ID: @.***>
Hello, in my case it was the check on "Optimize Wall Printing Order". Unchecked that and the corner is ok now. So thanks again for the fast answer
Hello, in my case it was the check on "Optimize Wall Printing Order". Unchecked that and the corner is ok now. So thanks again for the fast answer
Kurt
Am Mi., 1. Juni 2022 um 09:41 Uhr schrieb Kurt Hennig @.***>:
Thanks, I'll check it out.
5axes @.***> schrieb am Mi., 1. Juni 2022, 09:38:
Could be an issue in this case with the parameter : "Wall Ordering" the default value brings a lot of problem. Try to set this value to "Inside To Outside".
— Reply to this email directly, view it on GitHub https://github.com/5axes/Calibration-Shapes/issues/99#issuecomment-1143225067, or unsubscribe https://github.com/notifications/unsubscribe-auth/ANVMUV4FX3YMBFHEKJQI7JDVM4HPRANCNFSM5XOQ4MQA . You are receiving this because you authored the thread.Message ID: @.***>
Hello, I tryed the Temp Tower twice with different Filament. On the Backside right hand inner corner there are always two little line to long. See Picture. Willemthefirst