-
### Description
It would be great if a preview of the model could be displayed before printing it.
Does anyone know if there are libraries available to render gcode as a 3d model?
I'll look into wh…
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
Cure depreciated several scripts from: https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Gu…
-
Unless it's somewhere I forgot to look I couldn't find any build instructions for the source code. I took a stab and I believe this worked: (I downloaded the source (tar.gz) and from within the extra…
-
### Cura Version
5.9
### Operating System
Windows 10
### Printer
Ender 3v2, Klipper
### Reproduction steps
Setting a combination of outer wall wipe and scarf seams of various settings.
Exac…
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
Auto mesh is moving randomly and clocking the wrong places
### Bug Timeline
As soon as setup
…
-
#### What were you doing?
1. Started a normal print job after a prolonged downtime.
2. During the downtime, there were power outages and network resets that caused IP Addresses to be reas…
-
The first layers will be laid fine but later on it will be pushing against the print and flexing the springs of my bed, and grind against the print.
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
After flashing to version 2.1.1 or 2.1.x, there was a problem with resuming printing af…
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### OrcaSlicer Version
OrcaSlicer_Linux_V2.1.0.AppImage
### Operating System (OS)
Linux
### OS Version
…
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
Hello, I read through a post and then downloaded your firmware. I then entered the command C104 …