-
When I try to compile one of the examples to upload to a **Nano Every** I get the following error:
`"This library only supports boards with an AVR, ESP32, ESP8266, SAMD, SAM, STM32F1/F4 processor."`
…
-
This works perfect in arduino mega. But when I use it in arduino due, there are several 'printf_P' error:
> AES.cpp:532:46: error: 'printf_P' was not declared in this scope
-
Hardware platform: Sparkfun SAMD21 Mini Breakout + BME280 sensor + VL53L0X sensor
Software platform: Arduino 1.8.3, Arduino SAMD Boards 1.6.20, Sparkfun SAMD21 boards 1.5.3, Windows 10 Pro 1803
Ai…
-
Hello, raspberry PI Pico, can it be used as CORSAIR COMMANDER PRO?
-
Trying to set up a project for some led fun with adafruit m0 boards, using this flake
```nix
{
inputs = {
nixpkgs.url = "github:NixOS/nixpkgs/nixpkgs-unstable";
flake-utils.url = "githu…
eyduh updated
10 months ago
-
IDE 1.8.13, Platform linux64, Ubuntu 20.04.1
Have not be able to update boards using board manager. This error is the same as reported #10335 (and closed) last year. The apparent solution does not …
-
## Description
I am currently trying to find a way to flash an Arduino MKR 1010 Wifi using avrgirl-arduino. After tinkering around with different board configurations i realized that none of the su…
ma-ku updated
3 years ago
-
Hi - as a part of looking into setting the BQ24195L's OTG pin high to enable 5V boost operation, I've been poking around the board.
I have two boards, and on both, R26 is completely absent.
Can …
-
Hello everyone.
I'm working on a XBEE project with SERIES 1 Digimesh firmware. I have tested every example setting request and response as ZB and address at 64 bits. All is working as expected with…
-
I've been trying to get the blink sketch running on a Trinket M0 but have so far been unsuccessful. Output from pin 1 is buffered to through a 1g126 to 5V. The same setup works just fine with the Neop…