-
Hi!
First of all good job!
I have a question, I have defined two zones, but on homekit I see three irrigation accessories:
…
-
-
## Expected Behavior
1 - In order to be consistent with the pneumatic valves it should be linked to STATE_RBV _error_suffix = ":STATE_RBV" .
2 - Need to add one more command pv. Fast shutter has t…
-
Create commands that toggle valves.
**Engine On**
Sets the valves to such a state the O2 and RP1 are flowing.
**Engine Off**
Sets the valves in such a state that no O2 or RP1 are flowing.
**Flush…
-
This issue was raised previously via email to me and i did this quick dirty trick in boiler.php to accommodate over run for circulation pump/boiler pump. i have same issue in my place but i have this …
-
Is it possible to use a pneumatic air line instead of the blower?
Here in Brazil, all campaign beds are equipped with hospital pneumatic air and oxygen lines.
Could you add a pressure sensor to gu…
-
Our battery and cloud powered Melnor Raincloud/Aquatimer has been flaky off and on for years. Now even new batteries aren't resolving the problem. Also, there appears to be possible battery acid insid…
-
Dear,
I have a set of Philips HUE lights which are connected to HUE brige.
I also have a set of TRADFRI switches.
My intention is to disconnect the HUE Bridge and add all components to my Raspb…
-
When the print cooling fan come on there is a high pitch noise. I believe this is cause by the high frequency PWM signal going to the FAN.