-
Did anyone already manage/ try to implement support for the eCozy Smart Thermostat (http://ecozy.de/en)? I can pair the device, but do then get "Device not supported" warnings in the log. If noone els…
-
arXiv论文跟踪
-
i messed with the config file all day and i don't know what im doing wrong.
when i auto home the head goes to X:130 Y:160 instead 110x110
when i try to level the bed it goes outside of the bed.
my …
-
Hi i need some help getting my bl touch to work
about my setup i am using prusa i3 rework with a e3d hotend and titan extruder my bed is 200 x200 180
the bltouch offset is on the x 30 it is in the r…
-
Hello, I am having an issue with adding my second extruder motor, I recently put dual heads on my printer and am trying to get everything set up. I am using arduino ide 1.8.5 and marlin 1.1. The x, …
-
Hi
I have recently got printrun. However, it does not connect to the printer with a marlin firmware installed on a clone of Arduino Mega. What should I do? I run it obviously with sudo pronterface.py…
-
Hello
I am trying to update to the last version, i have tried with both versions 1.1.9 and 2.0, and my probe does not stop at homing.
Z_min is below bed level and I use the z_probe as Z_homing.
…
-
I installed BLtouch on my homemade printer with Marlin 1.1.9 recently and it doesn't compensate the bed leveling. Before I installed BLtouch, the bed limit switch for Z axis seems to work perfectly wi…
-
### I need help on my 3d Printer, the bed size is 400,400 but i only try to use 330 by 300 but when i do the bilinear auto bed leveling it would say probing failed at the 7th probe, i tried reduci…
-
Hej Guys.
I have compiled the 1.1.9 marlin to my corexy printer, and i have the probe sat at 30mm(-30) to the left of the nozzle. My bed size is x175 y165 (z242)mm when i do the G28 and G29 with th…