-
Hi, i have a custom project using the nrf5283 SoC from Nordic.
I have used the maxim algorithm to test the data i am receiving but the data seems to be incorrect.
I have attached a batch of data…
-
- [x] Pulse & SPO2
- [x] Temperature
- [ ] Gyroscope
- [x] GPS
-
We are using the ESP32 to receive the information from the MAX 30100. The returned value on the oscilloscope is right, which means that the value returned by the sensor is right. The value is 0x11. Bu…
-
The Portmaster was not able to initialize the nfqueue. This might be connected to #82 - but in that case the error later changed to not being able to initialize iptables itself.
**What happened**:
…
-
Strange, your code works with ArduinoIDE, but could not be linked with VisualMicro, giving the following errors:
`core.a(main.cpp.o)*: (.literal._Z8loopTaskPv+0x4): undefined reference to setup()
…
-
Could you continue the list of sensors in your project?
Or may be you can give an idea how to do it by myself)
There are sensors which I need to detect::
HTU21
BH1750
TCS34725
GYUS42
DHT12
MLX…
-
Hi guys, I can't install my kernel after gerate RPM' files, I try for 4 times to rebuild the kernel, with and without Cattarrapas modules I only use to set fsync everytime, I try to disable ACS and en…
-
### Hardware:
Board: ESP LoRa32 TTGO 3pcs
Core Installation/update date: 2/JAN/2019
IDE name: Arduino IDE with espressif
Flash Frequency: ?40Mhz?
PSRAM enabled: …
-
### Troubleshooting checklist
- [OK ] I read the README (on master) thoroughly
- [OK ] I ran the MAX30100_Tester and I'm going to paste the output down below
- [OK ] I filled in all the details o…
-
### Troubleshooting checklist
- [x] I read the README (on master) thoroughly
- [x] I ran the MAX30100_Tester and I'm going to paste the output down below
- [x] I filled in all the details of my s…