-
I am trying to compile a Merlin project using Visual Studio 6.1.5 on Windows 10. This project compiled OK in previous versions of Visual Studio(8 months ago). I finally got the file to compile OK but…
-
### Bug Description
**Expected behavior:** 1:1 accurate movement of each axis
**Actual behavior:** After updating the Anycubic Mega Pro with the [MEGA_P_DGUS_TMC_v1.4.3.hex](https://github.com/k…
-
I'v got an BIGTREETECH SKR 1.4 Turbo connected to the TFT 35 V2 using the RS232 Port on the TFT and the TFT port on the board. Updated the screens firmware, set the baudrate @ 250000 on both Marlin (o…
-
Hello Terje Io and All.
Same question like in #88
I want to use BTT motherboard with STM32H743VIT6 cpu.
How about progress with STM32H7 ?
May I help you some how?
-
The "CoolStep" example is perfectly working in my code. I have made zero changes to the said example code except keeping CoolStep enabled throughout the execution of my code, but there's one kinda bi…
-
This library uses SPI_MODE_0 by default, but Trinamic SPI interfaces use SPI_MODE_3.
I'm amazed that this library works so well when using the wrong SPI clock polarity and phase.
-
First of all thank you for writing this nice library. It is exactly what I needed and it works beautifully on my Raspberry Pico with 3 steppers powered by TMC2209 drivers.
While working, I wondered…
-
### Controller Board
esp32 dev kit c v4
### Machine Description
Just a diy project to move rods on a linear axis
### Input Circuits
```yaml
DIR_PIN 25 // Direction
STEP_PIN …
-
Hey there,
got one TMC5130 v1.5 Board, running a Nema 17 motor (200 steps/rev) via SPI. I first tested ramp mode 0 and when I set xTarget to 200*256 (256 = stepping) the motor did a 360° turn. In vel…
-
### Did you test the latest `bugfix-2.1.x` code?
No, but I will test it now!
### Bug Description
It appears the TMC26XStepper library is now a 404:
```
Library Manager: Installing https://githu…