-
On Surface Studio 2 (not listed in supported hardware, I know), the latest kernels 5.9.6 boots well, but the PC **shuts down abruptly** after a few seconds (up to minutes sometimes) after open…
-
# A Measure of Faith - Probability in Religious Thought · bblais on the web
[https://bblais.github.io/posts/2019/Jul/15/a-measure-of-faith-probability-in-religious-thought/](https://bblais.github.i…
-
你好，
我用命令bash ./scripts/multivariate_forecasting/Traffic/iTransformer.sh，结果很差，只有周期（这个直接FFT就行，不需要ai），没有其他信息。
[3140.pdf](https://github.com/thuml/iTransformer/files/14092595/3140.pdf)
excahnge的结…
-
[Description of the bug or feature]
I installed Ubuntu 24.04.1 LTS on my Surface Go 1 and added the surface-kernel and nearly everything works like a charm. Only the camera is acting strange.…
-
This is a topic that will be very important when we start implementing actual gameplay.
Once the fundamentals have been implemented OpenSAGE will face a bit of a dilemma: how do you play and test i…
-
I am pondering how to think about packet rates in the 100G era. How should we be designing and optimizing our software?
Consider these potential performance targets:
- A: 1x100G @ 64 Mpps.
- B: 1x100…
-
### Description
Hi,
```
root@DietPi:~# ls /dev/apex_0
ls: cannot access '/dev/apex_0': No such file or directory
```
I found similar issues already discussed, like [here](https://github.co…
-
Thesis defense target: 21 June 2024. Survey target: end of July 2023.
Would like to have a fresh master thesis topic, not incremental improvement of other thesis work.
Starting roughly Q1 2023 or su…
-
Hi,
I have had a couple of gear prints that fail get bad print results when using OcotPrint. The same gcode in repetier via a pc works perfectly without any small stops or hesitations in the movement…
-
I noticed #221 and I am having a similar issue but its also a little different.
When using anything that is high performance (`make -j` for a large project, or 3d games, etc...) the laptop gets very …