-
Hi, after a firmware upgrade my Anycubic Photon didn't turn on anymore, the fix dead, z-axis...file didn't work but with this file I fixed my printer. I want to share it with you.
[firmware issue…
-
### Cura Version
5.7.2
### Operating System
Windows 10
### Printer
Anycubic i3 Mega
### Reproduction steps
I've upgraded from Cura 5.5.0 to 5.7.2 and encountered a problem with a …
-
Hello,
the test does not work for transparent resins; in my experience and confirmed by others on the facebook page. If this is the case, it should be mentioned on the frontpage. If its not the cas…
-
Small pixel errors are shown on the display as of release amz_melzi_bed_bl_a2-bugfix-2.0.x-20210311-firmware.hex
Printer: Anycubic Mega Zero 2.0 with stock Melzi board, BL Touch attached to exp-a2 co…
-
**Application version**
4.8
**Platform**
Windows 10 X64
**Printer**
Anycubic Mega S
**Reproduction steps**
In Windows Multi Screen environments it is possible to set different zoom levels…
-
```
//AFR was #define HEATER_0_MAXTEMP 285
#define HEATER_0_MAXTEMP 300
```
PTFE tube and other components can't ensure such high temperature.
```
//AFR was #define DEFAULT_AXIS_STEPS_PER_UNIT…
-
Hello. I have a printer, ANYCUBIC PHOTON. I want to use it for more than just printing. Tell me if I can display an arbitrary image without using slicer (preferred image format *.BMP, or any other)? A…
-
Newest firmware isn't listed on their support site even though my printer came with it pre-installed.
The source would help compile custom Marlin for this printer.
ghost updated
2 years ago
-
### Description of the bug
Coming from v2.7.4, then trying to run the new AppImage for 2.8.0, it would simply not load. Attempting to run in terminal showed two causes, only one of which I could corr…
-
This source code seems to be incomplete. It uses define of mega_zero board, but that board is not defined in makefile/boards.h. Which bits are not published?
Which Marlin version was used as a base f…