-
Hello,
I've been using this driver for about a year now, and everything works fine, except a little problem during winter:
I have configured `CURRENT_FROM_VICTRON = True` and `OWN_SOC = True` beca…
-
Like I mentioned in the forum I would like to use 75mV shunts with ina229 addon board. I have tried to alter CurrentMonitorINA229.cpp and CurrentMonitorINA229.h
It works but not precise. The value i…
-
Hi. I'm trying to connect to an EASUN battery.
Link to battery:
https://www.easun-energy.com/products/easun-5kwh-10kwh-powerwall-48v-lifepo4-battery-bms-communication?srsltid=AfmBOo
The only missing feature is Balancer turn on/off switch.
I cannot find it in the modbus registers…
-
### What happened?
Hallo, wenn Strom eingespeist werden soll, dann speist der Wechselrichter (Hoymiles HM-1200) oft nicht ein, sondern beginnt irgendwann mal. Das Gerät hängt an einen LifePo4 Akku 25…
-
Having "Dual range 125A -5A" as current sensor configured should at least give me the opportunity to limit the DCL/CCL to 125A, because the cable and fuse are dimensioned for this maximum configuratio…
-
Thanks for your hard work @pvvx !
For once, I'm not asking anything, but wanted to share some test I have made.
I am using LYWSD03MMC (HW rev: 1.5) sensors in very cold weather (as you do too) and t…
-
Hi, what does the discharge rate in % mean?
My battery’s discharge rate is 0.5C , how should I put it in %?
-
Some "by default" values are wrong for LiFePo4 batteries:
