-
Hi, I´ve got the same problem.
How to solve this:
Use the Micro-SD-Card an fomat as in the README told.
Use FAT32 and 4096 Bytes!!!
Then copy the DWN_SET to the SD-Card.
Without Power put the…
-
### Bug Description
It would seem that filament runout (and M600 colour change and user initiated pause) is not going to be so simple to implement in anycubic_TFT.cpp for Marlin 2.0. The way the he…
-
just wondering if the configuration.h and configuration_adv.h files in the example folders are already setup for the MKS ROBIN NANO v1.2 board with TFT35 V1.3 display? I found them inthe Marlin-bugfi…
-
### Description
On vanilla marlin, using standard screens (not the custom anycubic ones) you can add "Start Host Print" and "Stop Host Print" buttons to the UI. I believe these buttons use the `M11…
-
Hello. We create the klipper firmware for the anycubic vyper. He has a strain gauge too. How can we contact you? We would help.
-
Hi, I've found that SKR releases only uses smart filament sensor, infact, If I compile and use SKR_BTT_MINI (for mega zero 1.0 version) and enable filament_sensor, I have false positive, so when start…
-
Hi,
i use Octoprint in the Version 1.3.10 on my Rasberry PI 3.
I connected the Orginal Anycubic Filament Sensor Typ "NUP-LED Switch Ver 1.2" to PIN 7 on the Pi.
It is the new HW Version what is u…
-
### What happened?
I couldn’t figure out how to comment sry. But can you add a way to make a proxy so I can use this on my school chrome book? I can acces my printer and thingiverse but I am just mis…
-
### Bug Description
Installed to Hex File on a Anycubic Mega-S in wanted to use the Arc Welder plugin which needs Arc Support.
G2/G3 commands give out an error, which should mean that Arc Support …
-
any one can help am use mks tinybee on kossel linear plus
tmc2209 x4
am test all config in Marlin 2.0.9.2 have bug layershift it jump when print long 15cm + layer have shift any one can help fix thi…