-
I created a sketch to automate my blinds, but when I call any fourth servo, causes esp to hang for a few minutes, and no servos can move. However, I am still getting a 'success' response from the ESP…
-
how to control more than 2 servos?because there were only two pwm(pwm0 and pwm1)
-
I need to test a nonlinear controller for a fixed wing aircraft. I am using Pixhawk 4 with Raspberry Pi as my companion computer. Pi will run the control algorithm parallel with the pixhawk. I want to…
-
Currently the maze is running three microcontrollers and a region of interest detection with a closed loop camera system. This is certainly an overkill for the tasks we are running, and complicated as…
-
- we rely on cheap continuous rotation analog sg90 servo motors for the flippers/ears on the RSC
- they cause vibrations, noise and electrical feedback noise when operating
- no position feedback mea…
-
-
Could also be considered a feature request?
TL;DR: Control packets are sent during start up that inconsistently make servos and cause unwanted behaviour in builds, but cannot be influenced by the c…
-
does this library still work? I can't seem to control the servos with a Docker container running Ubuntu 20.04. `lsusb` still brings up the Pololu Maestro device, but none of the commands work. I have …
-
We're currently working on a project that requires to move two robots at once using degrees. Is it possible in anyway? Like opening a void or something like that? Or is it only possible through a for …
-
Hi,
I cant realize how to work with two servos and their ID in servo.h It seems I can only control one. If someone could explain me more about this part would be great.
Regards.