-
Inverter Pip-5048Mg Fw71.85 QPIRI=103...FW71.82=QPIRI=102
This my Qpigs answer:
Tue Feb 16 05:07:18 2021 INVERTER: QPIGS reply size (110 bytes)
Tue Feb 16 05:07:18 2021 INVERTER: QPIGS: 110 bytes r…
-
Hi all
I'm trying to add my LYWSD03MMC sensor but recieving this issue
Logger: custom_components.ble_monitor
Source: custom_components/ble_monitor/__init__.py:542
Integration: Passive BLE moni…
-
Hola, como estas? te felicito por este proyecto.
Tengo un mpp solar 5048gk y lo conecte por MQTT (usando ned-kelly/docker-voltronic-homeassistant) y después de ardua lucha pude hacer que mandara al s…
-
Hi,
I have a problem firing it up. I have SKYMAX Inverter, same as Infinisolar, only case is orange not green.
Downloaded software, and when i try to run it:
pi@raspberrypi:~/isv $ sudo ./isv --ge…
-
I have tried getting the correct buffer sizes for the inverter.conf however I cannot get the correct values.
Could you please advise as all my sensors are showing as unknown in home assistant..
…
-
# Problem/Motivation
Upgrade from 0.4.0 to 0.5.0. Nut Started with error
OS: Raspbian supervisor install
supervisor-2021.02.5
core-2021.1.5
> (Why the issue was filed)
## Expected behavior
n…
-
I have a easun 24v 2,4kw inverter , i change this value
// PCM and PIP inverters use below
QpiMessage _qpiMessage = {97};
QpigsMessage _qpigsMessage = {110};
QmodMessage _qmodMessage = {5};
Qpiw…
-
Hi,
I installed this tonight and got it working to the point of polling data into home assistant via MQTT. I have enabled influx in the config and pointed it to my InfluxDB but I am getting no inpu…
-
Several inverters seem to return a different response depending on the firmware version they are running.
- It appears that they all start with the same data as per the protocol manual (battery/pv …
-
Hi, thanks for this project!
I receive only NAK response... which setting for "-M"?
Regards,
Elia