-
Hello,
I am trying to use my plutosdr with QUISK and it only works in RX mode and not in TX mode. I strongly suspect the problem is not with QUISK or SoapySDR but the SoapyPlutoSDR module that seem…
-
Hi Folks,
I have libiio installed OK, rsdlib tests OK, and the PlutoSDR fails on the following test. I'm running OSX High Sierra, running condo / macports. Here's the error and I'm guessing there's…
-
hi,
SDR have a rx and tx simultaneus. example limesdr, bladerf adalmpluto.
the frequency depend of the hardware 30mhz -3800, 70-6000 ....
-
Is it possible to connect openwebrx to plutosdr with SoapyRemote?
I have installed openwebrx on raspberry pi and I would like to connect it with plutosdr in SoapyRemote mode via tcp.
What do you…
tmlll updated
4 years ago
-
With current implementation, where service name and type are hardcoded in iiod, only first service is successfully published with DNS-SD, subsequent fail because the type/name pair collides with the e…
-
Hi,
I'm trying to use libm2k Python binding on Mac.
Followed "Building on OSX" section at
https://wiki.analog.com/libm2k
then ran
> python setup.py install
It looks the compilation and inst…
-
When I set on my mac machine the parameter scale(dBFS) in DDS Mode for "one cw tone" or "two cw tones", I can't see any tone outputs from the board.
When I do the same configuration from my ubuntu ma…
-
Hello
I faced some problems when I tried to build with Xcode.
After configure and generate with CMake. And opened Xcode project, ran "run_tests" . Compiler shows many errors.
**Here are some m…
-
Many thanks for posting your ADALM-PLUTO notebook. I have a very similar setup (OpenSUSE, etc.) and I am seeing exactly the same issues you had. I've already ordered my hub. I hope that gets this t…
-
Hi Everyone,
Apologies if this is basic. I've tried compiling 1/ from src, 2/ via macports, and 3/ via the prebuilt installer. I keep coming up against this error:
```
Chris-MacBookAir:build ch…