-
Hello , did somebody tried to use this library as motion controller mode.
Meaning that sending speed and destination via SPI and chip has full control motor ?
thanks a lot.
-
Rebooting the MMU can cause it to go down the menu - flashing LED5, flashing LED4, then they all light up green for a bit, then just LED1. No movement.
Then nothing mechanical moves, buttons don't …
AbeFM updated
6 years ago
-
TMCM-6214 and TMCM-1260 are identical in terms of USB identification.
On Linux, LSUSB command shows the following for TMCM-6214:
```
Bus 001 Device 003: ID 2a3c:0100 Trinamic Motion Control Gmb…
-
-
I would like to add my hotend fan to the following which can be found in configuration_adv so that the fan turns off when its lower than 55 degree and turns on which it reaches 55.
#define E1_AUTO_…
-
printer: Anycubic I3 Mega-S (upgraded)
board: 8 bit trigorilla 1.0
I'm running a mixed (tmc2209/A4988) stepper driver configuration (A4988 on extruder). and i am very confused about configuring th…
-
Hi
Is it possible to support, 64 pin STM32F103RC with 256 Kbytes of Flash memory? so I want to use BTT SKR MINI E3 V2.0 3D printer board.
https://www.bigtree-tech.com/products/bigtreetech-skr-mini-e…
-
This is a bit of a meta-issue, as I have not found a discussion forum (as yet) for g2core.
My interest is in using g2core for 3D printing. From the commit history, my impression is that support for…
-
For kinetic:
- [ ] fail gracefully if a standard mode does not work
- [ ] ~~auto-support all
-
Processing esp32 (platform: espressif32 @ ~4.0.0; framework: espidf; board: esp32dev)
--------------------------------------------------------------------------------
Verbose mode can be enabled via…