-
branch: 15.10
## steps
- Load model
- Let it slice
- at this point dragging triggers a reslice
- save gcode via File>Save All>Save to File
- see error log below
- get message that it has been saved
##…
-
For my prussa, I have not foung a way to parameterize CURA for the fan not to stop.
I have included in start GCODE this line that starts the fan :
M106 S255 ; Starts the fan full speed
A…
-
I built CuraEngine on 2 different architectures, here are the results of each. Notice the E values.
**Linux 3.18.0-trunk-rpi2 #1 SMP PREEMPT Debian 3.18.5-1~exp1.co1 (2015-02-02) armv7l GNU/Linux**
…
-
I found some info about the PinkUnicorn version on the forum: http://umforum.ultimaker.com/index.php?/topic/8606-whats-happening-in-cura-land/
But besides that information is scarce. I understand time…
-
This is probably my fault, but the pop-up asked me to post.
Version: master
Platform: Darwin-14.5.0-x86_64-i386-64bit
Qt: 5.4.1
PyQt: 5.4.1
Exception:
Traceback (most recent call last):
File "/usr…
-
I get this error when trying to run the latest code from here (Github).
Hope you can give any suggestions while I'm using my own packaging, because running a standalone package also doesn't work for m…
-
i ran out of filament and had a big topless object with the infill exposed the other day..
i just took a close look, and the structure was both quite solid but also easy to pry away by hand, leaving …
rabe- updated
9 years ago
-
Mac OSX 10.10.3
I cloned this directory and run:
```
cmake .
make
```
I get the following error:
```
CMake Error at scripts/ECMPoQmTools.cmake:142 (find_package):
Could not find a package conf…