-
Here is the picture of the board from the 5/16/16 Systems Meeting. We are going to use an attached power supply ($30) for the board (a battery can still be used if needed) and an IO expander ($12) in …
-
### What happened?
I have "Turn LEDs on after power up/reset" unchecked.
Upon power up my LED strip turns on.
Upon restoration of power after a power cut the LEDs turned on for 6+ hours with nobo…
-
I've got 3x Model Ms I've fitted with the Model-H board.
All working nicely as a keyboard but all have different issues relating to the Num/Caps/Scroll lock LEDs.
Any suggestions?
### 1988 "Si…
-
Problem:
After initiating an EMERGENCY STOP, Klipper is unable to successfully reconnect to the Nevermore controller. This results in the printer being inoperable until a powercycle of the nevermore …
padok updated
15 hours ago
-
### Issue Description for STM32 Motor Controller Workbench
**Understanding STM32 Motor Controller Workbench for Custom Hardware**
This issue focuses on leveraging the STM32 Motor Controller Work…
-
### BlueRetro firmware version
24.10
### BlueRetro firmware specification
HW1
### BlueRetro firmware variant
System specific
### BlueRetro hardware type
Internal install DIY
### Manufacturer
…
-
## If you believe there is an issue with the firmware itself please follow these steps:
1. Describe your problem;
Everything looked fine when I have recieved FC from the manufacturer
Betaflight co…
Be133 updated
2 weeks ago
-
I'm finally getting around to trying to setup my fan controller. I'm struggling with the dallas temp sensors, and hoping someone can help.
I have the 2.0 rev of the board with three 1-wire sensor a…
-
I extracted part of my comment from #178 because I think it deserved another issue:
Raspberry PI becomes a liability due to their politics and pricing and recent versions become more expensive than…
-
I have 5 SSD's it will only let me use 4 of the 5. Iv had this same problem with HDD as well. Im using and HP Z230 on board controller card. If tried other controller cards get the same results. Zima…