-
### Overview
When starting the OT-2 Robot it will boot for about 1 minute, and then reset itself.
During this time there is a brief connection to the OT-2 app which then states that the robot is …
-
I tried to plug in a USB 3.0 Hub with 3 USB and one Gigabit Ethernet interface and found the Ethernet interface not recognized. It looks like the VisionFive2 kernel from Debian-202306 is not compiled …
-
I tried to plug in a USB 3.0 Hub with 3 USB and one Gigabit Ethernet interface and found the Ethernet interface not recognized. It looks like the VisionFive2 kernel from Debian-202306 is not compiled …
-
I finally got got my setup working to successfully build the project. Right now, I am testing the device using the sdimg output, with plans to ultimately update the nor flash...
When I connect the r…
-
**Describe the bug**
If I switch to nvidia envycontrol -q says it's set to nvidia but everything seems like it's in hybrid mode.
If I launch nvidia-settings it still shows the intel GPU running a …
-
Thank you for your work - I will note af few observations. Hopefully some of them can be fixed:
1) The version of openwrt is rather old. /etc/banner:
`Based on Openwrt 21.02
IOT Freedom For End-…
-
ZNDMWG04LM does not reset password firmware 1.0.7_0019
== Gateway Global Tool version:20240218==
>>Power ON Gateway NOW!name=ms_main_intc, parent=gic
ms_init_pm_intc: np->name=ms_pm_intc, pa…
-
Opening new issue as requested
Cannot for the life of me get the RM2 into Recovery Mode.
So far I've soldered the Pogo connections to the pins to ensure that its a solid connection - these were …
-
I've tried various versions of the driver including 1.9.0, and when I plug in the adapter I get errors like this
[34688.799667] usb 3-2.2: new SuperSpeed USB device number 11 using xhci_hcd
[34689.13…
-
I'm compiling just the hello laser but I get the same in my own code. I can hear the blanking shutter click and the green box next to the etherdream name turns red. This happens once every few seconds…