-
The local Amateur Radio Club Repeater near me uses YSF.
I was wondering if you can add support for this, or if its already implemented why isn't it listed as YSF in the encoders
-
hi there, it appears I missed a lot :)
not sure which gnuradio are you including in PothosSDR now (probably 3.8 am afraid to touch it since all my old xml based grc files will not work anymore (and…
-
I have a working Svxlink setup, version 17.12.2-4 running on a Raspberry Pi4
I've tried to add an SDR to improve receive range and no matter how I config I get terrible interference on the audio. S…
-
The checklists below indicate which blocks have C++ support in master.
gr-analog 25/34 :heavy_check_mark:
- [x] analog_agc2_xx
- [x] analog_agc3_xx
- [x] analog_agc_xx
- [ ] analog_am_demo…
-
I would really appreciate if decoding of (non-encrypted) TETRA was added. I appreciate that it's much more complicated than most other features, and if this is out of scope feel free to close the issu…
-
Should be pretty easy to take some values (freq range, gain, etc) from a new web page, stop services, run the scan, show the png file right there on the page.
-
I'm trying to use a QT GUI Range (type int) to adjust RF Attenuation in a flowgraph.
I have the id for this variable defined as 'lna' and the default value is 0.
When I start the flowgraph it prints…
-
Dear Scateu:
The result of kal for my hackrf like this:
```
~$ kal -s GSM900 -g 40 -a 1 -l 62 -g 40
kal: Scanning for GSM-900 base stations.
GSM-900:
chan: 9 (936.8MHz + 9.492kHz) power: 47473…
-
I have tried to compile and run the code on a Raspberry Pi 3
My radio receives the signal, but the voice is very slow like an 45/min disc running 33/min (Yes I was alive when those exist)
In my /b…
-
sdrtrunk 0.6.0 release
macOS 10.15
RSPduo
I observe that RSPduo's spectrum is expanded compared to hackRF and rtl-sdr. It can be seen that adjacent P25p1 channels overlap each other. On hackRF th…