-
Hello, i'm developing an acceletometer sensor network (Arduino) and i'm having problem receiving data on the master node (Raspberry Pi), slaves are identified sensing an ID byte on the message and sen…
-
Hi,
Ran the script with my geeekpi ups.. I have ensured I2C is enabled...
Any suggestions or anything else I am missing? Running Rasbian
pi@raspberrypi:~/upsv3 $ sudo python3 demo.py
Traceback …
-
Hi,
I'm using this library with the Gravity I2C digital wattmeter which uses the INA219 sensor. According to the schematic the value of the shunt resistor is 0.01 Ohm not 0.1 Ohm. Could you please …
-
Hi there. I tried the link you have below to purchase the components to build the through the hole decoder but it appears none of the components listed are valid. I am assuming there are newer/alterna…
-
```bash
pi@luke-pi:~/Documents/upsplus $ sudo ./install.sh
[info] Welcome to 52Pi Technology UPS Plus auto-install Program!.
[info] More information please visit here:.
[info] --------------------…
-
when i run these instructions this is my response
> Method 1
> NOTE: Do not power off or disconnect the network during the upgrade process. If the upgrade fails, the UPS Pro will not work normally…
-
**Device type**
- [x] ESP32
**Framework version**
- [x] ESP-IDF latest master
**Describe the bug**
Is it possible to use the libraries in two different tasks (1 Task und 1 Interrupt r…
-
I have the INA219 installed and am running 3.0.0 dev 2
When loading the run page you have to open one of the other tabs before the sensor tab will open. Once you have opened another tab it works no…
-
Discussion about the power supply concept
-
Hi,
Can I use this sensor with UWP and Raspberry pi? I saw examples python and arduino but I don't figure out How Can I use with UWP? Do you have any suggestion?
Thank you. Best Regards.