-
In kiwix for iOS app, to improve usability, I try to group zim files by category, e.g., wikipedia, Wikivoyage, stack exchange, etc.
I currently rely on name property and file name to figure out th…
-
## The Issue
Have lots of subscriptions in my app and ran into this error when running the below. the size should be no different than resolving 100 claims, which we do for homepage content.
…
-
Again using the HS300 if relevant.
Printer never turns on if I had Countdown Timer enabled and off set to 300, on set to 0. If I disabled countdown timer, printer came immediately on. I had GCODE…
-
According to #750, this issue has been raised before, but was only partially addressed.
In its current version, Cura tells the user on first launch that Ultimaker is collecting anonymous slicing st…
-
Please create gyroid infill that is the shape as graphene. This shape has been shown to be very strong as a 3D printed object and if used as an infill would presumably create very strong 3D prints
…
-
**Application version**
4.2.1
**Platform**
Win10 x64
**Printer**
Creality cr-10S
**Reproduction steps**
I tried to slice much models a lot of times, I ended a 1kg roll.
**Actual result…
-
Availabel here https://ia800500.us.archive.org/22/items/stackexchange/stackexchange_files.xml
-
# Expanding Your World
In this assignment, you will end up with a simple styled web page, published on the web.
Create a new website that shows some basic styling and formatting using HTML and CSS. …
-
spee.ch/LBRYCreditsAcceptedHere should redirect to https://spee.ch/c/LBRYCreditsAcceptedHere
But instead it goes to an older abandoned claim: https://spee.ch/@3dprinting:5/lbrycreditsacceptedhere
…
-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…