-
Hello Dropax,
thanks for your work here.
Are you planning to upgrade as well to 2.7.0?
-
Thank you so much for putting this together for the Eachine racer 250. Is there any chance you can update this to reflect the newer release from the BorisB firmware?
Again, thank you for creating thi…
-
Hi All,
I was initially running 2.9 then 3.0 r6 then r12. Since r12 I have had to flipouts when the quad has been armed. Motor 3(rear left) is the cause. It does not spin. This has happened on two se…
-
Dear Goebish,
First of all, thank you for adding Bayang/Eachine protocol support. But to be honest, I'll be glad to make a tutorial of How-To use nrf24-multipro because it is not clear, at least for m…
-
As reported in #1473 (but separated out into its own issue here), enabling Autotune with CC3D results in a boot fault. I'm guessing with MWRate mode included CC3D is running out of memory. This might …