-
heishamon.yaml
sensors are giving unknown see picture
i have not changed anything in yaml file all others sensor/switches works perfectly
![image](https://user-images.githubusercontent.com/29598723…
-
Hello
Really a great system!
I have my system integrated with home assistant. The first day i had H76 Communication Error. Solved by disconnecting the Heishamon reconnecting it. Then reset error…
-
Hi, i have just flashed heishamon on my wemos D1, plugged a level shifting to match voltages with heat pump and got a problem with GPIO15. Having it connected to level shifting part making boot not po…
-
As long as I have the "Listen only mode" enabled, I receive 100% correct data.
In MQTT log, I see Total Reads and Total Good Reads with same values.
When I disable Listen Only and reboot, data get…
-
I am using my Panasonic J-series Heatpump with external thermostat, connected to the special Thermostat connector on the main PCB. In the installer settings it is set to "External Thermostat". This w…
-
Hi,
I have a Panasonic WH-SDC07F3E5 and unfortunately the connector for CN-CNT isn't soldered on the PCB so I turned to the CN-NMODE connector instead.
I bought [this HeishaMon interface on Tin…
-
My HP has a Max Pump Duty setting in the standard remote controller.
When I set it very low to e.g. 0x5A (which is 90 decimal), the pump will run at a maximum of around 1950 rpm.
This RPM can be f…
-
https://github.com/Egyras/HeishaMon/blob/c08377209c3e0c61fd99201f560fd62b46797edf/Integrations/Home%20Assistant/heishamon.yaml#L576-L613
Please fix that, COP calculation should be after power calcu…
-
In the schematic there is no level converter for the TX part.
This means that the heatpump only gets 3.3V as TX level.
Most proberly due to voltage drops, the heatpump get only 2.7V as TX level
I…
-
- Connecting a S0 kWh meter to GND and the port marked '1' on the PCB makes it show up in software as Port '2'
- MQTT topics for S0 connected on Port 2 is described in Readme as:
panasonic_heat_pu…