-
- [x] Create manifest (https://github.com/Halium/halium-devices/pull/35)
- [x] Boot image and system image build successfully
- [x] Device boots into rootfs, `usb: Manufacturer: GNU/Linux Device` ap…
-
### Checklist
- [X] Checked the issue tracker for similar issues to ensure this is not a duplicate
- [X] Read the documentation to confirm the issue is not addressed there and your configuration is s…
-
As discussed on ##linux-surface, hardware buttons on some Surfaces are not working. Reloading the button module works post-boot:
```
sudo modprobe -r soc_button_array
sudo modprobe soc_button_array…
-
Hi,
thank you for releasing this project. I'm trying to run it on a 5.4 kernel according to the README. I have ported the kernel patches and the kernel boots and seems to work just fine. I'm using th…
-
### Describe the bug
I have intermittent system crashes with the following setup:
* Raspberry Pi 4B, rev 1.1, 4 GB RAM
* USB case: Axagon EE25-XA6 (ASMedia ASM225CM, enabled UASP and TRIM, USB 3.…
-
### Describe the bug
I tried to connect two JKBMS via bluetooth on an freshly installed venosOS, but the RP 2 w i'm using keeps getting stuck while "building wheels for dbus-fast .." and seems to cra…
-
## Expected Behavior
E5785 is visible as cdc_ether and allows internet access using it's own gateway IP 192.168.8.1
## Current Behavior
Doesn't work at all.
It's visible as /dev/cdc-wdm0 but l…
-
I tried to run "python tools/create_data_nusc.py --root-path ./data/nuscenes --out-dir ./data/nuscenes --extra-tag nuscenes2d --version v1.0" and got this error log:
```
Traceback (most recent call …
-
> **NOTE**: The board used for this testing was a pre-release revision. The final producti…
-
**Is this the right place for my bug report?**
Yes: I asked on the [forum](https://www.raspberrypi.org/forums/viewtopic.php?f=28&t=295829&p=1817220&hilit=ptp#p1817220), I asked the raspberry foundati…