-
Hi guys.
This EBYTE E18-MS1PA1-PCB module does not work after flashing.
I try 2 different modules and the result is the same - after reflashing, it does not start.
Connected GND, 3.3V, P2.1, P2.2,…
-
DRF1262T module uses 1 pin for Antenna switching using SW pin.
I had a skype conversation with them and they said:
1. we use the PE4259 as RF switch
SW pin is used as the power supply for the …
-
Hello,
I'm trying to figure out how to adapt the code to the ttgo tbeam as it seems a nice device for aprs use.
I've disabled the aprsIS and wifi part to be able to fit the code in the tbeam, the i…
-
I have a sender (Arduino Mega) and a Receiver (esp32, heltec v2).
These are the params:
```
MEGA
----------------------------------------
Model no.: 45
Version : D
Features : 14
Mode …
-
I get this error when I try to flash an Ebyte E73-2G4M08S1C module. I have updated the firmware already to the newest version.
The host PC is Linux Mint 18.04.1.
There is only the small green led o…
-
Ciao Renzo!
I'm trying to do a project where I tell my sender E32 which receiver address it will send the message to. I give the address info via serial monitor. I ask the user to provide the ADDH…
-
Further to our other chats,. I see that there is no collision control right now.
I see that KISS has P-persistent CSMA as part of the protocol.
And the Mysensors library I use RFM95_sendWithRetry w…
-
### The problem
When using the ZHA integration with the ITEAD Zigbee 3.0 USB dongle I am unable to pair a variety of devices (Phillips Hue & Ecosmart) bulbs. The integration seems to install correct…
-
Hi please some help,
I'm using phpseclib to connect to my sftp using two methods
1 - using username and password
2- using private key
both cases i can connect with success using fileZilla bu…
-
Can the bellows library be made to support newer EZSP serial protocol such as EZSP v6, v7, and v8 when used with ZNet 6.x on Silicon Labs EFR32 (Mighty Gecko family) based Zigbee radio adapters?
Se…
Hedda updated
3 years ago