-
Is there maybe a possibility to add the Magnet holders for Voron TAP to the toolhead mounts? Maybe the screw for fixing the cutter arm could be moved to the front, so there would be room for the magne…
-
#### Sourcing right rfid tags can be hard so to make it easier for everyone please share your working/non working tags here.
### Add following information:
**LINK**: https://lab401.com/products/mi…
-
#### Description
There's a RISC-V (RV32IMAC) chip family called CH58x (sometimes also CH5xx, prominently CH582 and CH583) from Nanjing Qinheng Microelectronics Co., Ltd. (https://www.wch.cn/ / http…
-
I had a similar idea last week and started working on it, and then very quickly found your project.
I've read through the code and mostly follow what's going on - in particular in the PIO file, but…
-
Hi!
I was playing around with the recovery feature on VisionFive2 and I had no luck getting it to work at all with a TTL-USB converter using this device:
```
Prolific Technology, Inc. PL2303 Seri…
-
-
Hello,
is this firmware compatible with following device?
https://www.aliexpress.com/item/-/1005001413753569.html
I suspect that is not THE original NanoVNA, but i really like the steel box pro…
-
I have a PN532 module plugged in HSU (UART) mode with a usb serial adapter.
Using `nfc-poll -v` and scanning various RFID cards and tags works flawlessly, but trying to scan a `YubiKey 5 NFC` doesn'…
-
`ED052TC4` is a neat and affordable (10-20$) 5.2" high resolution screen with 720×1280 (WXGA) with 283 PPI similar to the one used in the LilyGo T5 but with higher resolution.
It uses a 50pin `WP27…
-
If it helps... After trying the I2C '23017 chip for an address latch, I ended up using a pair of 74HC574's in cascade which is much faster than designs using serial-to-parallel chips. It takes a lit…