-
-
### The problem
- MH-Z19C CO2 Sensor is connected to ESP32 and integrated in Home Assistant
- Sensor has been outside for 30 Minutes, but it shows 800ppm
- I tried to use a manually triggered Zer…
ar-ml updated
5 months ago
-
### Issue
When using sht41 sensor in "normal" or "low-power" mode everything is working fine. However when I set single-shot mode, CO2 reading values are incorrect:
- for measure-mode = "single-sh…
-
My 680i appears to throw a lot of CO2 sensor alarms, and I hoped to disable.
I tried using both the Homebridge UX, as well as setting the property manually in the config.json. However, in both cases,…
-
Hello there,
could you please add an option to disable the CO2 sensor? It seems to be pretty unreliable because the CO2 is only calculated (not measured) and seems to rely on the VOC for calculating …
w194 updated
9 months ago
-
**Bug description**
```typescript
const houseCO2Sensors = hass.refBy.label('house_co2_sensors')
const sensor = hass.refBy.id('some_house_sensor')
if (houseCO2Sensors.includes(s…
-
### The problem
I have a Wemos D1 mini used for an air quality sensor that workds flawlessly.
However, when trying to add an ST7735 display via SPI I get an issue.
### Which version of ESPHome…
-
### **Resultados Pruebas 9-11**
Se utilizaron dos muestras:
- 1. Alto contenido de MO (M1)
- 2. Bajo contenido de MO (M2).
Se realizaron 2 repeticiones por muestra.
- 1. (M1-r1)
…
-
-
**Describe the bug**
When using the sample code for ESP32 and updating it for the MQ135 per the MQ135-all sample code, I run into the "Warning: Conection issue, R0 is infinite (Open circuit detected)…