-
I`m just discovering the existence of LoRa and have bought an RFM95 and connected the following pin-out
`
PI Port RFM95 Port
3v3 = VCC
GND = GND
GPIO10 = SPI_MOSI = MOSI
GPIO9 = SPI_MISO = MISO
G…
-
If the waterfall resolution is high, and there's a narrow-band signal (like CW), then the fine tuning of the receiver can cause stations to disappear. Here's how I reproduce it:
1. Tune to an HF ha…
-
I couldn't find any documentation regarding the security of the application. Is there any encryption protocol applied to data sent from person to person?
-
Hello,
Is there any plan to support the Airspy HF/Discovery SDR?
Thank you
HFATL updated
3 years ago
-
The hardware module fs20 and rfm12 do not only controll the hardware but also implement the application protocol which leads to
- complex modules
- code duplication
- conflicts
The existing modules …
-
Since the HF band conditions have been a bit more stable the past weeks, and i got my power supply for the remote equipment a bit more nailed down
ive run across a thing that might be of benefit to a …
k9wkj updated
8 years ago
-
Hi, I am seeing the follwing messages
wsprdaemon@rx888:~/wsprdaemon$ sudo journalctl -u radiod@airspy.service -f -n 30
Jun 07 21:18:12 rx888 radiod[2859436]: dropped 4,096
Jun 07 21:18:12 rx888 r…
-
Salute Benny.
know issues.
The vote commander menu dont work in JIP.
The Heavy factory dont load the list.
Tip change map to Altis so you get a bigger teater and can use jets and so on more …
-
Just organizing info about the radio's CB166 SBC & STM32 onboard computers.
### x6100 DispUnit (Allwinner CB166 single-board computer) 'front-end'
Allwinner R16 CB166 ([MYZR-R16-CB166](https://www…
-
Jason,
First thank you so very much for all your effort in providing the si5351c library. This has been extremely helpful to me as I modify the 'all band' [0-2 GHz disciplined transverter](http://son…
n6gn updated
6 months ago