-
```
I have kliment/sprinter installed, motor will move when pololu in the x. No
movement when trying to run in projector mode.
```
Original issue reported on code.google.com by `digitalt...@gmail…
-
**Describe the problem you have/What new integration you would like**
I would like to see support for the STM VL53L1X sensor for ranging distances and detecting objects.
**Please describe …
-
```
I have kliment/sprinter installed, motor will move when pololu in the x. No
movement when trying to run in projector mode.
```
Original issue reported on code.google.com by `digitalt...@gmail…
-
Hi, can you confirm that line 363 in yaaap.ino is not necessary and that cmd should be computed on line 381 every time?
This is great code. I'm working on using it with a oled screen and a pololu l…
odani updated
4 years ago
-
```
I have kliment/sprinter installed, motor will move when pololu in the x. No
movement when trying to run in projector mode.
```
Original issue reported on code.google.com by `digitalt...@gmail…
-
Needed some parts to round out the full set of equipment:
- Raspberry Pi 3 A+
- Case for RPi
- Wemos D1 Mini parts:
- 3x power shields
- 6x batteries
- Pololu Altimu10-v5 (6x)
- Adafruit…
-
The library depends on the Pushbutton libraray, but because there are several around in PlatformIO, the PIO libraray manager complains:
> Library Manager: Installing Pushbutton
> Library Manager: …
-
Hi,
I have recently configured Teacup Firmware to work on Arduino Uno with 4 Pololu stepper drivers, but how to set Teacup to be used on Delta Printer?
Is there any implementation of Delta Kinematics …
-
Hey,
I am trying to find the right settings for a Pololu Stepper Motor NEMA 11 Bipolar 200 Steps Rev 28×45mm 4.5V 0.67 A Phase for chopper configuration but even though I calculated the parameters …
-
Hello,
Quickly comparing Pololu_Open_IMU code with your OpenIMU generic library I don't find the code issued from Madgwick algorithm... Am I wrong or you've removed it for now ?
Maybe it is what you …