-
### The problem
Using this `/config/rtl_433/rtl_433.conf.template` file:
```conf
# config for rtl_433
# A valid config line is a keyword followed by an argument to the end of line.
# Whitespa…
-
Hi class thermostat work Perfect, but class HeaterCooler dont work properly.
This parameters are for mqqthing for class HeaterCooler
{
"accessory": "mqttthing",
"type": "heaterCooler",…
-
I'm testing the binding of https://community.openhab.org/t/comet-blue-eurotronic/36590
Now I can bind.
How can I create the XML files?
Where to put?
How to add an extra coefficent to each radia…
-
Continuing the discussion in sinara-hw/meta#52 ([comment](https://github.com/sinara-hw/meta/issues/52#issuecomment-624352053)) on cheap monitoring photodiodes for Sinara.
- Something like Thorlab…
-
High voltage supplies are commonly required in ion trap experiments. These are widely commercially available but typical models have many of the following drawbacks:
- Noisy output
- Radiated RFI…
-
Hi,
I have now deleted all the trace elements of the pre 1.0 version.
I have uninstalled from HACS.
I rebooted
I then re-installed in HACS.
When I try and configure in the integrations,…
-
### Link
https://moeshouse.com/products/zigbee-programmable-thermostat-006?variant=44869537956155
### Database entry
'homeassistant/switch/0xa4c13897d0e2954a/switch/config', payload '{"availa…
-
First install went well.
2 contact sensors detected and working 100%
1 motion sensor detected but not detecting motion.
...
I had created a full backup just before installing WyzeSense so I went …
-
### Link
https://moeshouse.com/collections/smart-thermostat/products/zigbee-smart-thermostat-gas-water-heater-room-thermostat-digital-programmable
### Database entry
{"id":3,"type":"Router","ieeeAd…
-
**Describe the bug**
Schneider Exxact Wiser outlet seems to report W and Wh a factor 1000 off (or HA/ZHA seems to think so at least). Ie a 900W load is reported as 900kW
**To Reproduce**
Steps to…