-
Hello,
I am using the timer library to generate 100 Hz PWM on four pins, which can have different duty cycles. In my current implementation, the timer misses one cycle every 500ms or so, where it jus…
-
### The problem
When using a pump and only the last valve is enabled pump is not turned off after last zone run duration has ended.
Another problem is listed below.
Setup:
Sprinkler Controller …
-
Raspberry Pi Model 2
Raspberry Pi OS Lite 32-bit version
Mycodo 8.15.8
The Situation:
I have Mycodo controlling a 4-channel remote (wifi) relay via Output On/Off: MQTT Publish (paho-mqtt).
Th…
-
In the current design document the strategy for providing power to sensors and valves on board the platform is to route a power line through the rotary joint (up to 24V, 2A) which can then be split in…
-
Hi,
We have a requirement for a Gas Solenoid Valve on a project.
Currently there is a water solenoid valve defined as SNV but no Gas Solenoid Valve. Suggest we either update the SNV to just be a…
-
When defining an experiment it is currently possible to specify the value of task variables for individual subjects. However some variables are more naturally associated with individual hardware setu…
-
Hi,
not really an issue but a (probably dummy but I couldn't find it anywhere) question:
how does this compare to open sprikler firmware that runs on Rpi?
https://github.com/OpenSprinkler/OpenS…
-
We unfortunately are not familiar with the pneumatics APIs, so we will do our best to teach you. For reference, look in Robot2022 and observe the "Intake" subsystem (we used pneumatic pistons to relea…
-
An error is popping up when attempting to concatenate the 10Jul2017 data for VCSS. Most likely the cause is the fact that there is a subset of columns that have an extra row. This can happen when the …
-
I have 8 individually wired lights. (5 microbrites, 1 globrite and 2 magicsteam laminars).
Each is individually wired back to my panel area but I only have 4 transformers and an IntelliCenter i8PS. (…