-
Hi,
I tried to get the modules running, but without success. How can I check if the wiring is correct? Maybe a small test-sketch which reads a known register? And How can I produce a signal I can see…
-
I loaded the latest firmware to a CC2350+2195 but cannot get the temperature sensor to work. I tried router and enddevice firmware and connected a ds18b20 sensor to P0_7.
Zigbee2MQTT:info 2021-05-…
-
Please consider porting ESPurna to the new Sonoff Zigbee Bridge (Sonoff ZBBridge)
- https://www.itead.cc/sonoff-zbbridge.html
Itead has just launched Sonoff ZBBridge as an inexpensive Sonoff Z…
Hedda updated
2 years ago
-
Anyone tested compatibility with the new CC2674/CC2674P/CC2674R and/or CC1354/CC1354P chips from Texas Instruments?
https://www.ti.com/product/CC2674P10
https://www.ti.com/product/CC2674R10
h…
Hedda updated
2 weeks ago
-
## Hardware
ESP32
### RF Module
nRF24L01+
CMT2300A, Typ: E49-900M20S
### Antenna:
* [ ] circuit board
* [ ] external antenna (SMA)
### Power Stabilization:
3 x 22uF multilayer capacitor…
kiu77 updated
3 months ago
-
I'm trying to move over to the idf from Arduino because the esp32c3 usb support is absolutely terrible there. I was using the radiolib arduino library for the sx1276 and it works great. But it doesn't…
-
### What happened?
Since some time ago, I've observed a new zigbee2mqtt device in Home Assistant. It contains the sensors that until then, I configured using the "package" option.
One of them, is …
-
### The problem
I use a relay card based on Ebyte E72 module (c2652p chip) with PTVO firmware to control the floor heating. In the ZHA it is visible as: ptvo.switch, manufacturer ptvo.info.
So far t…
-
Zigbee is becoming the de facto standard in home automation. It would be great if `OpenMQTTGateway` could support this protocol. Below I have a write up about the most promising solution at the moment…
-
I am trying to flash the bootloader on a brand new chip (Ebyte E73 nRF52840).
Checkin if the chip is locked gives me the following result: Ok: the nRF is unlocked
I downloaded a few bootloaders in…