-
```
[12ms] Platform: ZuluSCSI Pico
[12ms] FW Version: 24.10.16-release Oct 16 2024 17:34:59
[12ms] DIP switch settings: debug log 0, termination 1
[12ms] SCSI termination is enabled
[12ms] Flash …
-
Hello,
I am using 3.5" TFT LCD Shield with Arduino Uno and its work great, but in other project i can't…
-
### Description / Steps to reproduce the issue
After [this PR](https://github.com/apache/nuttx/pull/14761) capture driver started to get some wrong values.
Steps to build:
`esp32s3-devkit:captu…
-
my HW esp8266 use sht30 via i2c on:
sda gpio0
scl gpio2
and SDS011 soldered to
sds tx-esp gpio5
sds rx-esp gpio4
if i choose this GPIOs in configuration sensor never began to run.
 are disabling sysfs access to gpio,
After an apt-get upgrade, direwolf will not run if using gpio,
Dire Wolf version 1.7 KM6LYW-4
Includes option…
-
my line:
```
gpio_pin_map = "3" : "gpio.mp4"
```
is apparently read, because the internal pull-resistor switches from pull-down to pull-up, which I can see with raspi-gpio.
I can also read th…
-
### Wiki Search Terms
_current_tool _selected_tool
### Controller Board
6-pack
### Machine Description
Queenbee (C-Beam based) with Huyang vfd
### Input Circuits
_No response_
### Configurati…
-
