-
Win10, NB42.2, Drivers 512.15.
CUDA Error: unknown error (err_no=30)
I try lower overclocking or no overclocking, but "CUDA Error: unknown error (err_no=30)"
New Drivers is also "CUDA Error: u…
-
Hi Alain, you may be interested in take advantage of the IDLE time of Sleeves. If your focus is to work for a single faction to get rep, keep rotating the sleeves just for a few seconds. This will mak…
-
### Describe the feature
@ rakashazi hello, will you add an option to overclock the CPU speed because games such as Road Rash 2 and Road Rash 3 run at 25 fps and after overclocking the CPU to 200% it…
-
Hello.
I run my RTX 3070s with +1,400 MHz memory overclocks which works fine if the overclocking is applied after the DAG is generated, but if the overclock is applied before the DAG is generated, …
-
This is being tested on Raptor Lake FSP from this repository, i9-14900K, 2x48GB 5600MHz Crucial Pro DDR5 with XMP 3.0 support.
I'm on the stage in our firmware building where I want to add XMP. I h…
-
This is not an issue, Just to let you know I finally posted a beta version of SdFat with RP2040/RP2350 support [here](https://github.com/greiman/SdFat-beta).
My main goal was Arduino users with sma…
-
By default, cloudBits stream their input voltage at a rate of 750ms. This is ok but not super-amazing for real-time responsiveness. max = 750, min = 200? 100? 50?
- [x] add to [cloud commands](https:/…
-
Not very hard, we just need to find the time.
Should mount the /SYSTEM partition, and edit the config.txt to change overclock settings, and for installing to USB, just specify a separate device (USB …
-
I have encountered some special situations. I hope that when the overclocking parameters are configured, gminer can overclock first, and then start running after the overclocking is completed.
-
hi guys
for some reason (because bug of vpu load maybe) cmp cards dont go to idle perfomance states without any load. gpu and mem clocks is always on boost-mode (p-state 0), instead p8 and 300/100mhz…