-
After following the installation steps, I've run into the problem of my models being made completely out of the support filament. I've set the left extruder (PLA) as the active one, and designated th…
-
I observe the search retry time being reset after each beacon even at a 15 sec interval (c++ servers later switch to a 3 min. interval). This is with pvAccessJava 4.1.3 (cs-studio 4.3.3b).
The tes…
-
```
I have installed SL4A r4 and Perl 5.10.1, created this script and attempted to
run it:
use Android;
my $a = Android->new;
print $a->smsGetMessages(0);
The script fails with message "Can't locat…
-
```
I have installed SL4A r4 and Perl 5.10.1, created this script and attempted to
run it:
use Android;
my $a = Android->new;
print $a->smsGetMessages(0);
The script fails with message "Can't locat…
-
```
I have installed SL4A r4 and Perl 5.10.1, created this script and attempted to
run it:
use Android;
my $a = Android->new;
print $a->smsGetMessages(0);
The script fails with message "Can't locat…
-
```
I have installed SL4A r4 and Perl 5.10.1, created this script and attempted to
run it:
use Android;
my $a = Android->new;
print $a->smsGetMessages(0);
The script fails with message "Can't locat…
-
I have been printing two material prints with two extruders. One material is PVA and the other is a flexible filament. The PVA is then dissolved away after the print. When The PVA prints first, the …
-
```
I have installed SL4A r4 and Perl 5.10.1, created this script and attempted to
run it:
use Android;
my $a = Android->new;
print $a->smsGetMessages(0);
The script fails with message "Can't locat…
-
Hi,when I use ckpt v1 format,the command line as follows,
python ./faster_rcnn/test_net.py --gpu 0 --weights ./models/VGGnet_fast_rcnn_iter_150000.ckpt --imdb voc_2007_test --cfg ./experiments/cfgs/f…
ygren updated
5 years ago
-
Observed on a Debian 12 host with an IOC, one of 34 PVA servers started in parallel during system boot. A later restart succeeds.
```
...: Error in pvxsBaseRegistrar : bad_alloc serverconn.cpp:44…