-
Hi there,
Just wondering if it was possible to use two or three different SPI displays with this driver? Ideally they would all have different things being displayed. Thanks!
-
I am trying to use mfrc522 RFID reader with the A9g.
I have found this Micropython class [https://github.com/wendlers/micropython-mfrc522](url)
It only supports WiPy, LoPy ,FiPy and ESP8266.
I kn…
-
How can we be sure we are connected to a particular SPI rack? There is the `get_firmware` method, but I do not see any method that can generate a unique identifier (e.g. something like a MAC address)
…
-
In order to add these LEDs changes need to be made to the circuit board. Place all changes that need to be made and suggestions here.
hsean updated
8 years ago
-
the default parameter should be linux_spi:dev=/dev/spidev1.0
-
-
On Electronics version 0.9 the SPIFlash library hangs on `flash.initialize()` because it calls `SPI.transfer(0)`, which always returns 255 with IC not present on this hardware version. This is a probl…
-
Hello, I couldn't get this library to work, until it hit me:
When using 5V Arduino, you NEED!!!! to add resistors for the MISO, MOSI, SCK lines. Otherwise it doesn't work and you risk damaging your c…
-
Reference manual (Multiprotocol wireless 32-bit MCU Arm®-based Cortex®-M4 with FPU, Bluetooth® Low-Energy and 802.15.4 radio solution - Reference manual) says:
![image](https://user-images.githubus…
-
It's possible to use this library with Lora modules (SX1276) which uses SPI protocol and not UART?