-
The title pretty much sums it up.
It's UPDI so only 3 pins if burning the bootloader works why can't I upload a sketch right after?
The sketch is as simple as it gets and compiles ok. I even switche…
-
I am getting the following in the terminal when attempting to flash a P8X32A-D40.
```
proploader.mac -k -D baud-rate=115200 -p /dev/cu.usbserial-P97z9aa5 "~/pixelmusic3000e.binary" -e
Opening fil…
k6lcm updated
2 months ago
-
```
What steps will reproduce the problem?
1. use ftdi chip as usbserial
2. command : ./stm32flash /dev/tty.usbserial-A9WJB515
3. output:
Using Parser : Raw BINARY
/dev/tty.usbserial-A9WJB515: Invali…
-
i try to close the connection but fail
it always show InterruptedException
i call `close()` at the end of my UsbReadCallback function , is it right?
on the other side , i can't send `write()`…
-
I was looking for something that I could setup to track my Kenwood890s and my SDR frequency. I THINK this is what I am looking for, I was able to make it on MacOS and run it. However, I think I must …
-
Hello,
i have ESP32 development board, which has ENABLE (RESET) pin connected to DTR of FTDI usb serial converter. This works very well when flashing ESP32 using Arduino IDE, but does not work when u…
-
I am just following instructions after I finished one engraving. The following is what the program want me to past here:
LaserGrbl v7.12.0.0
Grbl v
Wrapper: UsbSerial
Win 11, Home, 10.0.22631.…
-
I must be doing something wrong, can you point me in the right direction?
```
undefined is not a constructor(evaluating 'new _reactNativeUsbserial.UsbSerial()')
```
```
"dependencies": {
…
-
```
What steps will reproduce the problem?
1. use ftdi chip as usbserial
2. command : ./stm32flash /dev/tty.usbserial-A9WJB515
3. output:
Using Parser : Raw BINARY
/dev/tty.usbserial-A9WJB515: Invali…
-
## Expected Behavior
After start-up no continuous errors
## Current Behavior
continuous errors:
[ 262.968760] brcmfmac: brcmf_dump_obss: dump_obss error (-52)
## Possible Solution
no idea..…