-
### The problem
When the Tradfri-Gateway isnt reachable (e.g. Network Failure, Powerloss,...) and the Tradfri-Integration is still up and active, CPU Usage increases signficant (e.g. from 5-8% to 30%…
-
**Describe the bug**
After adding my thermostat the climate card - aside of the temperature control - only shows the `off`-button. When I click on it, the thermostat is turned off and I can't control…
-
I have some of the new Lidl smart bulbs and their colour settings are a bit odd. When in colour temperature mode, they act normal, but 1% brightness is very bright (I'd guesstimate it's at about 30-4…
-
### The problem
One LIDL motion detector without LIDL Gateway was integrated bevor same weeks.
Now a second device was detected but has no active entitys.
Details see below...
I have the same …
-
### What happened?
Set or Get color_temp_startup (Colour temperature after cold power on of this light) from the zigbee2mqtt Device UI reports an error. UNSUPPORTED_FEATURE.
### What did you expect…
-
### The problem
Hi,
I have 2 livarno led strip managed with deconz.
I can easily manage default color light using light_profiles.csv so I'm assuming that the light is correcly integrated by dec…
-
Somone managed to run it on a M1 MBP with Big Sur?
-
### The problem
I can not use the ZHA integration anymore.
Log gives the following
`Couldn't start deCONZ = dresden elektronik deCONZ protocol: ConBee I/II, RaspBee I/II coordinator
Traceback (m…
-
**Is your feature request related to a problem? Please describe.**
Device is detected and reports status OK when the command is made from the device itself.
When the command is made from the HA, it …
-
**The problem**
The device is identified and added. Reported readings are humidity, illuminance, power and temperature. The temperature is often reported as 0° C, and, when this happens, illuminance …