-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
When I upgrade from 13.4.0 to 14.1.0.3 Tasmota won't connect again. Wifi scan only shows 1 or 2 networks.
###…
-
Poundland Ultrabrite UK Smart Wifi Plug 20J ST3 (WB2S)
Got the device open but the wifi board labelled WB2S is very close to some capacitors so I only have access to one side.
tried lightleak setup …
-
Core. 2024.6.3
Supervisor. 2024.06.0
Operating System. 12.3
Frontend. 20240610.1
My Tasmota IR devices are all getting the error. Stack trace and YAML is below.
Thanks for any help to figure …
-
```
Rebooting...
ets Jul 29 2019 12:21:46
rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00…
-
I currently have panels that are already flashed with custom firmware. That allows me to easily switch from Tasmota to ESPHome. And of course I don't need direct HW access anymore. So my thought was t…
-
**Describe the problem you have/What new integration you would like**
I would like to add a wind and direction sensor to my weather station. Unfortunately, the TX20 / TX23 sensor is no longer manufac…
-
is there anyway to know how many lights 1 hub can support without a problem?
i got many lights on 2 hubs, and lately i get unexpected behaviour. (light A turning on results in light B dimming, even a…
-
Being in my holiday home with netfit thermostat moduline 2050 (ems 2.0) I recognized that the thermostat_hc1_mode does not work anymore (neither dashboard nor mqtt). No changes possible - no error rep…
tp1de updated
1 month ago
-
A functional error exists -in my opinion- in the calculation of the ConstT: this factor should compensate for differences between the inside temperature and the outside temperature. Current implementa…
-
### The problem
Warning in logs
Entity sensor.pracovna_energy_total from integration tasmota has state class total_increasing, but its state is not strictly increasing.
Hardware - Blitzwolf S…