-
Hey,
There is a support for STYTJ02YM - Xiaomi Mi Robot Vacuum Mop Pro?
I got exacly this version:
Model: viomi.vacuum.v8
Hardware version: Linux
Firmware version: 3.5.3_0017
Automatic Room de…
-
Check for fault before booting. Fault register should be read twice to handle transient errors.
Loop if voltage low. Indicate charging or fault with LED. On kernel start, set amber LED.
Tony: For th…
-
I've had reports of high 12V drain from a Kia e-niro owner running latest edge build.
Possibly the car is being kept aware? The drain rate seems to be higher than just the OVMS module. It's unclea…
-
Hi,
I have found some issues:
first, the current readings from both supply and batt in the python script are incorrect. it says the Raspberry consumes 2000mA
@5.0V resulting in 10W of power.…
-
### Description
Homebridge shows the devices have been discovered and are available, but HomeKit does not discover them.
### Reproduction Steps
Steps to reproduce the behavior:
1. Restart Homebr…
-
[root@hamzy-tp-p50 ~]# gphoto2 --camera "Sony Alpha-A5100 (MTP)" --list-files --debug
0.000153 main (2): ALWAYS INCLUDE THE FOLLOWING LINES WHEN SENDING DEBUG MESSAGES TO THE M…
hamzy updated
6 years ago
-
Hello! The event gate has been such great fun to work with, but after a good while of using it I've come up with a few more options that I think would take it up another notch. Most of these options a…
-
I was under the impresssion that the 2018 40kWh Leaf is currently not suported by OVMS since the OBD port in the 2018 LEAF is now behind a gateway, so it no longer hears any passive CAN traffic requir…
-
I have a setup with original hoverboard control board and battery and one sensor board connected to the right connector with RX/TX bridged to the left connector.
My right motor has two switched pha…
-
Is there a way to fix this error without having to add an extra code to configure the server to accept handshake w/ the ocpp2.0.1.1 protocol header?
### Server log
```
% go run .
INFO[2022-02-2…