-
root@cs-610301933215-default:/home/sobrinhosj# sensors
No sensors found!
Make sure you loaded all the kernel drivers you need.
Try sensors-detect to find out which these are.
root@cs-61030193321…
-
### 現象
- zybo-z7-10-pmods-petalinux.bit.bin
- zybo-z7-10-pmods-petalinux.dtbo
を以下の手順で読み込むと Bitstream, dtbo のロードは成功し、 GPIO として使えるようになるが
```
cdns-i2c e0004000.i2c: timeout waiting on completi…
-
Is it possible to use the i2cdriver like a native I2C port, enumerated in /dev/i2c-*?
On my Raspberry Pi, I use the Python smbus2 library to control I2C devices. I would love to be able to plug the…
-
i have an Acer Laptop with Synaptics 1B7F I2C Touchpads and it doesn't seem to recognize the touchpad as a Synaptics Touchpad.
Touchpad is detected as a Synaptics HID Device in Device Manager and i…
-
```
RSeries I2C is +5V vs NXP standard of 3v3.
The NXP standard, like the NunChuck connector is 3v3 VDC.
However to power the I2C FX Modules, we used 5VDC so that one 4 wire cable can
do both the I…
-
I have a setup with two 232H for two different I2C busses.
I can get only one to work at a time; if both are plugged in, the PY library stops working until I do a driver reinstall. This seems to be …
-
I did a hotplug of the Beng BegQ T2200HD, after which `libddcutil` correctly detected the new monitor, but an attempt to use `libddcutil` getvcp failed returning `DDCRC_INTERNAL_ERROR`. The command-l…
-
Add support for I2C Muxes such as the [TCA9548A I2C Multiplexer](https://www.adafruit.com/product/2717) to allow multiple I2C devices on the same address.
-
If I were to write a sysfs attribute, in most cases, `cat`ing it back should result in the same data I wrote, plus a newline being printed. Unfortunately, there doesn't seem to be a way to mock that b…
-
I am building a fairly complicated system with the pi3 and find that the two gpio you used are already in use by other boards. I would like to have the Pico UPS designed into the system as the usage…