-
### The problem
Warning in logs
Entity sensor.pracovna_energy_total from integration tasmota has state class total_increasing, but its state is not strictly increasing.
Hardware - Blitzwolf S…
-
I am trying to use SSID2 with no success. It always connects to SSID1 only (CFG_GetWiFiSSID() and CFG_GetWiFiPass()).
I couldn't find code in the source code that uses CFG_GetWiFiSSID2() and CFG_GetW…
-
The Nordic nRF52840 chip is inexpensive and has Zigbee ZBOSS support.
The [pca10059](https://www.nordicsemi.com/Software-and-tools/Development-Kits/nRF52840-Dongle) is only $10.
Nordic has an…
-
### The problem
I was updating the firmware on all of my Tasmota devices. As part of the update I have switched to different Full Topics on them. After removing all the devices, the integration, mult…
Fufs updated
4 months ago
-
**Operating environment/Installation (Hass.io/Docker/pip/etc.):**
pip on debian 10
**ESP (ESP32/ESP8266, Board/Sonoff):**
Sonoff Basic
**ESPHome version (latest production, beta, dev …
-
# TL;DR
* Release 2024.08.18 of OpenDTU-OnBattery require
* an ESP32 with **at least 8 MB of flash memory**
* **or** that you, going forward, upgrade using a wired connection (you forfeit OTA…
-
### Describe the issue you are experiencing
After updating to OS 13.0 All my cameras stop working.
I was using Hikvision and also Generic Camera integration.
After rolling back to 12.4 everything…
-
**Operating environment/Installation (Hass.io/Docker/pip/etc.):**
Docker raspbian
**ESP (ESP32/ESP8266, Board/Sonoff):**
8266 Sonoff basic
**Affected component:**
https://esphome.io/com…
-
upgraded to the latest version of the intergration and Home Assistant. Since upgrade, AC card no longer showing set temp. Changing the mode shows the mqtt messages being sent but temp is listed as 0.
…
-
As i dotn assign static IP addresses to all of my tasmota devices, i use the clean devices function to remove all devices and then readd with an autoscan.
For a number of weeks now the clean device…