-
I have load it to TTGo LoRA board. Set CFG_IS_CLIENT_MODE to false
#define CFG_DIGIREPEAT true
#define CFG_RF_TO_IS true
#define CFG_IS_TO_RF true
#define CFG_BEACON …
-
### PROBLEM DESCRIPTION
After I configure the webcam and reboot the module the webcam is not working.
With sample code the webcam is working fine, but not with Tasmota.
Error message in the logs:
…
-
Hi! One of my temperature sensors (DS18B20) for some reason consistenly gives exactly 10 degrees C more than the others. When I try to enter "-10" in the calibrate field, the value is changed to "6". …
-
Hi,
when i check display, I do see incoming APRS messages from several ID´s.
So, decoding is working, but then I check, which ID`s have been forwarded to APRS, I cannot see a single one:
e.g, 07…
-
Once `initDMA` is called with `ctrl_cs` argument as true, all non-DMA operations afterwards seem to be incorrect.
I'm using a 240*320 st7789v screen with esp32 (platfomio with arduino framework, esp3…
-
I need an Ethernet MQTT to BLE gateway that will enable me to control Bluetooth (BLE) radiator valves using MQTT. I anticipate that I will need two or three of these to cover my whole house. My curren…
-
Hello,
I’ve seen with the M5 config, that it might be possible to compile the code to build a tracker to use with the RFM69HCW rather then the RFM95, my goal is to straight up use the OGN network r…
-
Hi, When I set Tracker mode setting to 1, 2 or 3 it boots up in mode Tracker (=0). Set #define DONT_USE_FLASH_MEMORY on or off has no effect. It boots in Tracker mode (no WX). Only when I push the mi…
-
I have a number of sketches which work well on an ESP32 TTGO T-Display 135x240 TFT board with Arduino 1.8.9 (on Windows 10), but with 1.8.13, which I have just installed, the colours are very differen…
-
Hi Hansi,
today I did setup an additional new TTGO T-Beam from the latest series with 3 buttons.
I also did wire a new TFT 2" display based on your wiring scheme and both brandnew units worked we…
DL2MF updated
3 years ago