-
Hello, I hope I'm putting this in the correct location. The Jandy IQPUMP01 shows up in the Iaqualink app but not on the integration. Here is a log output:
_Logger: homeassistant.components.iaqua…
-
I am running a pda-ps8 combo with rev 7.1.0. Running current development version 2.4.1 dev 0.1. My system has the pda-ps8, Jandy 18 channel RF receiver, IAquaLink, and a Jandy variable speed pump. …
-
### The problem
The integration does not yet support eXO devices although a solution was proposed about 3 years ago.
Is it possible to officially integrate support for eXO devices without having to…
-
http://www.jandy.com/~/media/zodiac/global/downloads/h/h0570800.pdf
-
So, for ease of use, had to make the Dockerfile pull the aqualinkd-docker.cmd and aqualinkd.conf from my local repo for easier builds, and added at the bottom of the aqualinkd-docker.cmd the following…
-
Hello,
Sorry if it is not the right place to ask this but I just want to know if you can explain how to install this component to my fresh home assistant install.
I have install the official Jandy…
-
EDIT 2: Using the Aqualink Touch protocol `extended_device_id=0x31` works better - power / rpm goes to zero when the pump is turned off, shows higher power when priming, then the correct power / rpm a…
-
The value is expressed in Fahrenheit and when user default is in Celsius, HomeKit "converts" it.
Ex: 3200ppm shows as 1760C
Solution: Let the user indicate the temperature unit that should be used by…
-
Aqualinkd is running well. With the Aqualinkd Management Console, I have noticed an increase in checksum errors and bad packets. It does not seem to interfere with the operation.
Under v2.4.1 …
-
https://github.com/earlephilhower/aquaweb