-
Hi , i just wanted to know if this board is compatible with 245 tip series from jbc ? , i modded a ksger with the same fw you use on your custom board but cant get the 245 tips to work, so i'm searchi…
-
Sir, can you give me schematic for the handle wiring to T12 bits? its seems KSGER handle have difference wiring, and it has NTC. but is it you design need NTC?
If the wiring are difference i need s…
-
It would be nice for battery operation if the supply voltage could optionally be shown on the display.
Ideally there would also be an adjustable low voltage warning or shutdown via the menu.
-
I have a problem with my KSGER-T12 V3 soldering station.
I have downloaded the appropriate firmware ‘KSGER_V3_OLED_Release.bin’ to the soldering station. Unfortunately, it now keeps restarting when…
-
In the Simple example you have:
`String s; // global variable to avoid memory fragmentation`
Would a static String declaration inside the function calling FloatToAscii also avoid the memory fra…
DonWT updated
3 months ago
-
This repo has most KSGER schmetics but lacks this controller, plase add it from here:
https://github.com/deividAlfa/stm32_soldering_iron_controller/tree/master/BOARDS/Quicko/Schematic
-
Please add support for v3.3 board:
CPU: STM32F103CBT6
OLED display connected to PINs: 25 (PB12) SCL, 26 (PB13) SDA
Encoder - 38 (PA15) KEY, 39 (PB3) Pin A, 40 (PB4) Pin B
UART? - 42 (PB6), 43 …
-
I use KSGER V2.1 stations with an AD597 amplifier and GOOT RX-80HRT+RX-85HRT tips with a K-type thermocouple inside these cartridges. Which profile should I use out of the three Hakko T12 / JBC C210 /…
-
在固件中，我希望在手柄中添加一个倾斜开关，以实现低功耗，类似于ksger原始固件的低功耗模式进入睡眠状态。我没有特定的睡眠支架来睡觉，在低功耗模式下总是把烙铁倒置。
-
Hello,
I have just bought the KSEGR T12 and have the following controller board inside. I cannot find this board layout on any forums so I ask directly. Can I use your FW with this board?
Thank …