-
Hello
AFAIK since the release 0.2.0, the below error is reported in HA logs. I experience now often unreadable zone status never noticed before....
`Enregistreur: custom_components.koolnova_bms.co…
-
### The problem
Hi @martgras @0x3333
I'm testing a client modbus code that queries three different servers. If server `241` becomes offline, after 6 requests, a `1min pause` (3s*20) is observed an…
-
**Describe the bug**
Using the modbus subsystem, a response returned after a request times out would increment the semaphore and stay until the next request is made which will immediately return when…
-
packages are installed with
sudo pip3 install -U pymodbus pymodbusTCP
but still it not works and means "not found"
using last raspbian
2022-11-13 10:42:20.650 Error: Epever Batt Volt: (…
-
In debugging a customer's deployment that has very poor (
-
`--config` key starts server (ModSim) but client (ModScan) with correct configuration gets `Illegal data address (0x02)` error on connection.
When I update any configuration on server during this co…
-
Everything works fine for 6 days and then TB stops seeing GW. The GW continues to poll devices and receive telemetry normally
gateway polls devices using serial port Modbus RTU protocol
restarti…
-
```
/*
Modbus-Arduino Example - Master Modbus IP Client (ESP8266/ESP32)
Read Holding Register from Server device
(c)2018 Alexander Emelianov (a.m.emelianov@gmail.com)
https://github.com…
-
Today i saw the message „Failed to setup“ in the integrations panel. Logs show Python errors see below.
I‘m using HA Version 2024.10.0. It last worked with 2024.9.x
Logs:
Logger: homeassistan…
-
## The refactoring in October 2024 requires some bugfixes and other things that need to be implemented
- device builder parses `configurationList` and can use default values
- device builder valid…