-
### Plugin Name
homebridge-texecom-full
### Link To GitHub Repo
https://github.com/K1LL3R234/homebridge-texecom
### Plugin Icon (Optional)
_No response_
### The plugin does not offer the same no…
-
Hi,
If possible, could you add a functionality to reconnect or check if connected? (Possibly multiple times?)
I ask as after about a few hours of the plugin working I get this log and then it st…
-
It would be really great if you could add support for the Texecom alarm plugin, if not too much effort, although aware supporting all these plugin requests is a big ask.
The simulate device data …
-
So Sometimes (rarely) i'll get an accepted command which comes through as ZXXX1 or ZXXX0, but most of the time texecom is sending a pre-fix as follows:
[8/1/2020, 6:40:45 PM] [Texecom] IP data rece…
-
Hi there - my Wintex settings are the following (image attached), Texecom Connect Hub is hooked up via Ethernet.
and my config is very basic -
```
{
"areas": [
{
…
-
When the alarm sends an arm/disarm state change notification to the plugin, the current state is set correctly (so you get a HomeKit armed notification for example). But it will say "Disarming..." on …
-
**Describe the bug**
Everything works as expected for a few hours, then I receive the below log. If I reboot the container a few times or the raspberry pi it sorts its self out but super weird?
As a…
-
I can now see the alarm and the sensors in HomeKit. When the sensors are activated I get a HomeKit alert. However, when I change the state of the alarm from the alarm keypad (or from the Connect app) …
-
The app is great, I used VeraPlus Zwave for years. Biggest problem was to integrate Texecom Premier Elite alarm into home automation. Have your plugin up and running on HomeBridge.
If I could make …
-
In the README it states "It does not currently support arm/disarming.", Is this a limitation of the texecom connect protocol or a limitation of this project?