-
I would like to ask the developers to add some simple functions:
- A function to vary the GPS update frequency
- A function to disable NMEA sentences and use the UBX protocol
- A function that al…
-
I would like to use AssistNow Online/Offline with the u-blox GPS on the Tlera Corp Gnat board. Is there a way to do this while playing nice with the GNSS library? Is it possible to do it as simple as …
-
Thank you for the library but i have some extremely critical feedback.
I've used a TON of arduino libraries and normally I rave about the Arduino platform, libraries, their structure, and how the e…
-
Maybe I missed something, but I couldn't spot anywhere in your code where you are setting the dynamic model of the uBlox GNSS chipset.
If you don't set this to one of the airborne dynamic models (I r…
-
Is it possible to use this library on the UBX M8P for RTK purpose (base-station)?
- configure dynamic model
- get the RTCM3 corrections (1005, 1077 and 1087)
If not, do you plan on supporting it,…
-
I'd like to use the OpenLog Quiic to log binary data. That works fine with the original OpenLog over serial.
When I try to log binary data from Sparkfun u-blox GPS chips in .ubx format, the data are …
-
Hello devs, thank you for your work.
Ive been using an old version of your filter (uNavINS) in arduino for a while and i just want to start using this version of the code. The problem I have is tha…
-
... with t-beam Rev1.
My T_BEAM_V10 is defined in the configuration.h , the RX and TX of the GPS is set right.
The blue GPS-LED blinks, even the t-beam is switched off!
I searched GPS for hours. …
-
Good day @flybrianfly
Thank you so much for your work!
I would like to use the `uNavINS` library code, but I see that for it to work you need a `NEO` GPS module with the `uBlox` protocol.
I can ge…
-
Hello,
I always receive this message when running the serial monitor for my arduino micro:TimeOut UBX packet!
Even outdoor I have this problem.
Thank you in advance!