Hi, I know V5 is still under development but apparently this should work with the Ender 3 V3 SE.
However, when I try to slice and export the print it works, but the printer doesn't print properly and just shows 0's on estimated time, Filament used and layer height.
Not sure if I'm just being dumb or if a different setting is needed, I have tried on both the Ender 3 V3 and Ender 3 V3 KE profiles.
Hi, I know V5 is still under development but apparently this should work with the Ender 3 V3 SE.
However, when I try to slice and export the print it works, but the printer doesn't print properly and just shows 0's on estimated time, Filament used and layer height.
Not sure if I'm just being dumb or if a different setting is needed, I have tried on both the Ender 3 V3 and Ender 3 V3 KE profiles.
Has anyone else had any luck?
Edit: This works fine on version 4.3.*