search

DualSPHysics / DesignSPHysics

Module for FreeCAD intended to use with DualSPHysics fluid simulator.
Other
111 stars 40 forks source link

options off #177

Closed GiuliaClai closed 9 months ago

GiuliaClai commented 9 months ago

I created a simple geometry and the options on the right, in FreeCad (add fillbox; case summary. etc), were active. I closed and the model.FCStd folder was created. I reopened the model from FreeCad and all the options on the right are swiched off. How can I swich on these optns. I would like to define the liquid material that fills a part of my geometry and falls into the part below. Is there an example I can refer to? ​

Zahramht commented 9 months ago

I created a simple geometry and the options on the right, in FreeCad (add fillbox; case summary. etc), were active. I closed and the model.FCStd folder was created. I reopened the model from FreeCad and all the options on the right are swiched off. How can I swich on these optns. I would like to define the liquid material that fills a part of my geometry and falls into the part below. Is there an example I can refer to?​ Hello Giulia I assume You did not open macro first. first open macro and then choose the load case option on the right panel and enter your case that you created before.

GiuliaClai commented 9 months ago

Thanks Zahra, now I can see the right side options active.